The surge protector, referred to as SPD, is installed on a 35MM standard rail. For fixed SPD surge protectors, the following steps should be for routine installation. First, determine the discharge current path. Second, are the wires marked for the extra voltage drop caused at the equipment terminals? Third, to avoid unnecessary inductive loops, the PE conductor of each device should be marked. Fourth, establish an equipotential connection between the equipment and the Surge protective device. Fifth, it is necessary to coordinate the energy of multi-level SPD.

Precautions during installation: The most important thing during installation is the power-off operation. In addition, to limit the inductive coupling between the protected part and the unprotected equipment part after installation, certain measurements are required. Usually, we separate protected conductors from unprotected conductors, and also separate ground wires. Install according to the guide rail, and check whether the equipment can work normally after successful installation.

As a well-known lightning protection brand in China, Anhui Jinli has been committed to the electrical safety of electrical systems and focused on lightning protection technology for electrical systems. For the installation of surge protectors, we provide detailed installation instructions with each product. If you encounter problems at the same time, the technical department can remotely guide the installation. At the same time, we will make regular return visits and repairs. Provide customers with worry-free after-sales service.